Diy - Wooden Barn Quilt

Hi friends,

I kept myself busy working on my dining room project all week. The ceiling is done, crown molding done. I'm most create to pigment the entire thing. I demand to larn the pics from my outcry to part the progress amongst you. That would endure soon.

For now, I'm gonna part this piddling projection I managed to tackled inward betwixt all the major things going on. I can't hold back to start decorating for Christmas, in addition to this quilt is the i to become a overstep my fireplace inward the solid unit of measurement room.

Source

The stance of the wooden quilt came subsequently looking at this moving prototype a few days ago. Well, I stumbled upon this spider web site, where they were having a red in addition to white quilt show. If yous honey quilts, yous should catch them, they accept lots of beautiful quilt designs.

Red in addition to white's going to endure my Christmas subject this year, so, I merely had to conduct an tardily pattern for this project, because I was going to piece of occupation all those remnant pieces of ¼" plywood I used inward the dining room.

The pattern was sketched on paper, in addition to these are the materials you'll need:
-This post contains affiliate links-

1 - 33" x 33" slice of ¼" Plywood fabric for the back.
12' Screen Bead for the frame.
3" Squares in addition to Triangles every bit stated inward the inward a higher house moving prototype (¼" plywood material).
Wood glue.
Red in addition to white paint.
Clamps
Sanding sponge
Saw, Miter Saw

The offset pace was to cutting 3" strips out of ¼" plywood.

Miter Saw

I stacked 4 of those strips to brand things become faster piece cutting the squares in addition to triangles. Influenza A virus subtype H5N1 wooden stopper on the miter saw was merely about other agency to skip the continuous measuring.

It too worked for the triangles, the angled cutting was the solely change.

All those piddling squares in addition to triangles were cutting inward a thing of minutes.

I used a sanding sponge to polish out all those sides earlier prototype all the pieces.

Once they were dry, the puzzle was position together. Keeping the pieces inside the clamped frame.

After aligning the entire thing, I began to mucilage the pieces onto the ¼" backer.

I decided to stain the frame to laissez passer on it merely about contrast, then, it was too glued onto the backer board.

The frame is a really pocket-sized molding I had inward my stash, since it's too ¼" deep, it sits even out amongst all the design.

I run into piddling gaps that bother the perfectionist inward me. But hey, overall I similar it. I'm right away debating the stance of pathetic it a piddling chip or mayhap not.

What create yous think?