Tutorial: Construct Y'all Ain Chunky Article Of Furniture Feet
When I was writing the postal service for Mr. Don Draper Desk I realized it would get got WAY also long to explicate everything I did to the desk, summation include a tutorial on how I built the chunky feet. So hither is the follow-up tutorial.
I was going for a contemporary look, but you lot could operate the same process, amongst some molding instead of 1x stock as well as larn feet like to this.
source |
For reference, an average chair (kitchen, desk, etc.) sits at 18" high. An average tabular array or desk is closed to 29-30" high.
So, I started the legs yesteryear cutting 4, iv x iv pino posts downwards to 5" lengths.
I flipped the desk over on it's back.Then, using a framing square, marked lines on the exterior corners of the desk, 7/8 inwards from the edge.
Reaching inwards through the drawer openings, I drilled iv holes through the bottom of the desk, inwards each corner.
I as well as therefore lined upwards my iv x iv block amongst the lines drawn on the bottom of the desk, achieve through the drawer openings, as well as drilled through the pre-drilled holes, drilling into the iv x 4.
I did get got to deed a twain holes therefore they were to a greater extent than centered on the block.
Next, all I had to create was attach the blocks to the bottom of the desk, using woods mucilage as well as 3" woods screws.
I could get got chosen to move out the feet how they were. They wouldn't await also bad if I had painted them, but I wanted to a greater extent than substantial, contemporary looking feet.
On my tabular array saw, I ripped downwards some 1x boards to 5" widths (If you lot don't get got a tabular array saw, you lot could operate 1 x 4s or 1 x 6s. You volition merely take away to accommodate the summit of your iv x iv blocks to hold upwards the same every bit your board width.).
I as well as therefore cutting my 1x strips into 8, 6" lengths, cutting i side foursquare (90 degrees) as well as i side at a 45 grade angle (long side 6").
Next, I lined upwards the 45 grade corners of the pieces, on the exterior of the iv x iv block, as well as attached them amongst woods mucilage as well as complete nails.
I originally planned on merely roofing the two sides, filling the holes as well as calling it a day, but when I stood back, I realized that you lot could run into the hollow sides. It looked bad.
I filled the holes, gave them a lite sand, painted them to check the residuum of the desk, as well as they were done! I had my chunky, contemporary feet.
Linking at:
Remodelaholic
Designed Decor