Diy Hourglass

I've ever had a honey for hourglasses. My dream thrift shop detect would live an antique hourglass, precisely I'm non asset my breath till that twenty-four lx minutes current comes. In the meantime, I created my ain DIY hourglass from a couplet empty lather bottles in addition to a few supplies from the arts and crafts store. 

Materials List:

• (2) *Method construct paw lather bottles ("limited edition" bottles locomote best)
• (2) *5" diameter forest plaque
• (8) *wood push plugs
• (1) *replacement vino cork
• *fine arts and crafts sand
• *1/4" x 48" forest dowel
• *gold washi tape
• *clear multi-surface glue
• *spray paint

I was able to detect all the materials locally. The lather bottles in addition to pigment came from Lowe's. Using 40% off coupons at Hobby Lobby, I was able to selection upward the remainder of the materials for some $12. The cork was the exclusively affair that was a piddling hard to find. I was able to selection upward a replacement vino cork for some $2 inward the hardware department of True Value.

1. The get-go affair I did was to describe the cork off the plastic base, in addition to drill a 1/8" hole inward the center.

2. I emptied the lather from the bottles (and used it inward my decorative lather pumps), removed the labels, in addition to washed the bottles thoroughly. The "limited edition" lather bottles locomote best because the label is printed on a plastic wrapper, instead of printed on the bottle itself.

Once the bottles were dry, I used a modest hacksaw to cutting off the threaded business office of the neck. I therefore used a newspaper funnel to create total 1 of the bottles near 3/4 total of sand.

3. I therefore inserted the cork in addition to connected the bottles together.

4. To encompass the exposed necks in addition to cork, I cutting a strip of golden washi record near 3/8" broad in addition to wrapped it some the bottle necks. 

5. With the basic hourglass position together, I began to get together the frame. I cutting a foursquare of newspaper ii 7/8" across in addition to centered it on the decorative side of each forest plaque. 

6. I marked each corner of the paper, therefore drilled a 1/4" hole through the plaque.

7. I took 1 one pre-drilled plaque in addition to flipped it over. I therefore glued a push plug over each hole.

7. I cutting four, xi 1/4"  lengths of 1/4" forest dowel amongst my modest hacksaw.

8. Once the mucilage on the push plugs was dry, I flipped the plaque over.  I applied mucilage to the ends of each dowel in addition to inserted them into the opened upward holes. At this point, all the forest parts received ii coats of paint, including the 2nd plaque in addition to iv remaining push plugs.

9. Once the pigment was fully dried, I centered the hourglass on the frame in addition to attached it amongst a blob of mucilage on the bottom. 

10. I added some other blob of mucilage to the top of the hourglass, in addition to topped the frame amongst the 2nd plaque. I covered the holes amongst to a greater extent than mucilage in addition to push plugs, finishing the whole assembly. Once the mucilage was fully dried, I had my finished hourglass. 

I finally accept a traditional looking hourglass to display! I've asked everyone who has come upward over what they think, in addition to no 1 has guessed that I made it from onetime lather bottles.

 I'm earthworks the classic dark in addition to white scheme, precisely you lot could construct 1 amongst whatever colors you'd like.

I timed the sand, in addition to it runs for near 45 minutes. If I actually cared, I could play some amongst the total of sand in addition to the size of the cork hole to teach a specific time.

Ready to construct your own?! Pin the ikon below in addition to relieve the persuasion for later. 

*This post service contains affiliate links.

Let's live friends! Follow along, therefore you lot never missy a post